Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display standby flow ● 5
Command Reference
display standby flow
Purpose Use the display standby flow command to view statistics about the traffic on
the main interfaces participating in backup load sharing.
Syntax display standby flow
Parameters None
Example Set Serial 1/0/0, Serial 0/0/0 and Logic-channel0 to back up interface Serial 3/0/0 and
configure backup load sharing on Serial 3/0/0.
[3Com ] interface serial3/0/0
[3Com -Serial3/0/0] standby interface serial1/0/0 10
[3Com -Serial3/0/0] standby interface serial0/0/0 30
[3Com -Serial3/0/0] standby interface logic-channel0
[3Com -Serial3/0/0] standby threshold 80 50
[3Com -Serial3/0/0] standby timer flow-check 100
[3Com -Serial3/0/0] standby bandwidth 9
Display statistics about the traffic on the main interfaces participating in backup load
sharing.
[3Com -Serial3/0/0] display standby flow
Interfacename :Serial3/0/0
Flow-interval(s) : 100
LastInOctets : 868168
LastOutOctets : 1818667
InFlow(Octets) : 50070
OutFlow(Octets) : 100088
BandWidth(b/s) :9000
UsedBandWidth(b/s) : 8000
The following table describes the fields of the command.
Table 1 Description on the fields of the display standby flow command
Field Description
Flow-interval(s) Intervals for checking traffic on the main interface.
LastInOctets The sum of the octets received on the main interface until the last
check.
LastOutOctets The sum of the octets sent on the main interface until the last check.
InFlow(Octets) The sum of the octets received on the main interface during the last
interval.
OutFlow(Octets) The sum of the octets sent on the main interface during the last
interval.
BandWidth(b/s) Bandwidth of the main interface.
UsedBandWidth(b/s) Actual bandwidth of the interface during the last interval.