Command Reference Guide

210 ● info-center trapbuffer 3Com Router 5000 Family and Router 6000 Family
Command Reference
info-center trapbuffer
Purpose Use the info-center trapbuffer command to enable the trap buffer, set its
size and the channel that outputs information to it.
Use the undo info-center trapbuffer command to cancel the current
settings.
Syntax info-center trapbuffer [ channel { channel-number | channel-name } |
size buffersize ] *
undo info-center trapbuffer [ channel | size ]
Parameters channel
Sets the channel for outputting information to the
trapbuffer.
channel-number
Channel number. Valid values are 0 to 9. (The system
has 10 channels.)
channel-name
Channel name.
size
Sets trapbuffer size.
buffersize
Size of the trapbuffer (the information entries that can
be accommodated).
Default By default, information output to trap buffer is allowed and the trap buffer size is
256.
Example Enable the info-center to send information to the trap buffer whose size is 30.
[3Com] info-center trapbuffer size 30
View This command can be used in the following views:
■ System view
Description Only when the info-center is enabled can this command become effective.
By setting size of the trap buffer, you can allow the info-center output information to
the trap buffer.
Related Commands ■ info-center enable
■ display info-center