Command Reference Guide

206 ● info-center source 3Com Router 5000 Family and Router 6000 Family
Command Reference
Example Output IP module’s log information at emergencies and lower levels through the
SNMP channel.
[3Com] info-center source ip channel snmpagent log level emergencies
Remove the setting of the CMD module in the SNMP channel.
[3Com] undo info-center source cmd channel snmpagent
View This command can be used in the following views:
■ System view
Description For the specified module, by default,
The state of logging information output is on and the allowed information level is
informational.
The state of trapping information output is on and the allowed information level is
informational.
The state of debugging information output is off.
The system allocates one information channel for each output direction as shown in
the following table:
In addition, each information channel has a default record, where the module name
and number are default and 0xffff0000. But for different channels, the record may
have different default settings for log, trap, and debugging information. If a module
has no explicit configuration record in the channel, the default configuration record is
used.
When adding a new or duplicate record, you need to specify its log, trap, and debug
information levels if the default levels are not desired.
Tabl e 38 Default information channels assigned to each direction
Output direction
Information
channel No.
Default channel name
Console 0 console
Monitor terminal 1 monitor
Log host 2 loghost
Trap buffer 3 trapbuffer
Log buffer 4 logbuffer
SNMP 5 snmpagent