Command Reference Guide

3Com Router 5000 Family and Router 6000 Family flow-interval qos ● 37
Command Reference
flow-interval qos
Purpose Use the flow-interval qos command to configure QoS policy traffic statistical
interval and QoS policy rate updating interval.
Use the
undo flow-interval qos command to restore the default.
Syntax flow-interval qos flow-interval [ update-interval seconds ]
undo flow-interval qos
Parameters flow-interval
QoS policy traffic statistical interval, in the range 1 to
30 minutes. The default is 5 minutes.
update-interval seconds
Optional, QoS policy rate updating interval in seconds.
It takes the value of 10, 15, 20, 30, or 60 and defaults
to 10. The smaller the interval, the faster the updating
rate.
Example Set the QoS policy traffic statistical interval to 10 minutes, and rate updating interval
to 15 seconds.
[3Com ] flow-interval qos 10 update-interval 15
[3Com ] display qos policy interface e0/0/0 outbound
Interface: Ethernet0/0/0
Direction: Outbound
Policy: test
Classifier: default-class
Matched : 0/0 (Packets/Bytes)
10 Min Rate: 0 bps
Rule(s) : if-match any
Behavior: be
-none-
Classifier: test
Matched : 0/0 (Packets/Bytes)
10 Min Rate: 0 bps
Operator: AND
Rule(s) : if-match any
Behavior: test
-none-
View This command can be used in the following views:
■ System view
Description QoS traffic statistical information is displayed along with QoS policy configuration
displayed by the
display qos policy command.