Manualshelf

Command Reference Guide

ManualsBrandsHP ManualsRoutersHP 5000 Router Series
2391239223932394239523962397239823992400
3Com Router 5000 Family and Router 6000 Family start l2tp tunnel ● 71
Command Reference
start l2tp tunnel
Purpose Use the start l2tp tunnel command to enable the L2TP LAC to start L2TP
tunnel connection.
Syntax start l2tp tunnel
Parameters None
Example Enable the LAC to start L2TP tunnel connection. It requests the LNS at 1.1.1.1 first
and then the LNS at 2.2.2.2 if no response is received.
[3Com-l2tp1] start l2tp ip 1.1.1.1 2.2.2.2 fullusername vpdnuser
[3Com-l2tp1] start l2tp tunnel
CAUTION:
You must use this command in conjunction with the tunnel keepstanding
command. Otherwise, the tunnel will be torn down immediately after it is set up.
View This command can be used in the following views:
■ L2TP Group view
Description This command is used only on LAC side.
Related Command: tunnel keepstanding