Command Reference Guide

60 ● reset l2tp tunnel 3Com Router 5000 Family and Router 6000 Family
Command Reference
reset l2tp tunnel
Purpose Use the reset l2tp tunnel command to clear the specified tunnel connection
and all sessions on the tunnel.
Syntax reset l2tp tunnel { remote-name | tunnel-id }
Parameters remote-name
Name of the peer end of the tunnel, comprised of a
character string from 1 to 30 characters long.
tunnel-id
Local ID of the tunnel.
Example Clear the tunnel connection with the peer name of AS8010.
<3Com> reset l2tp tunnel AS8010
View This command can be used in the following views:
■ User view
Description The tunnel connection compulsorily disconnected by the reset l2tp tunnel
command can be reestablished again when the remote user calls in again. You may
specify tunnel connections to be disconnected by specifying remote name. If no such
tunnel connections exist, the current tunnel connections will not be affected. If there
are several tunnel connections (with the same name but different IP addresses), all of
them will be cleared. When tunnel-id is specified, only the corresponding tunnel
connection will be disconnected.
Related Command: display l2tp tunnel