Command Reference Guide

304 ● tunnel remote 3Com Router 5000 Family and Router 6000 Family
Command Reference
tunnel remote
Purpose Use the tunnel remote command to set the remote address of an ipsec policy.
Use the undo tunnel remote command to delete the remote address in the ipsec
policy.
Syntax tunnel remote ip-address
undo tunnel remote [ ip-address ]
Parameters ip-address
Remote address in dotted decimal format.
Default By default, the remote address of an ipsec policy is not configured.
Example Set the remote address of the ipsec policy to 10.1.1.2.
[3Com] ipsec policy shanghai 10 manual
[3Com-ipsec-policy-shanghai-10] tunnel remote 10.1.1.2
View This command can be used in the following views:
■ Manually-Established IPSec Policy view
Description For the ipsec policy in manual mode, only one remote address can be set. If a remote
address is already set, this existing address must be deleted before a new one can be
set.
The security tunnel is established between the local and remote ends. The remote
address must be set correctly on both ends of the security tunnel.
Related Commands ■ ipsec policy (Interface view)
■ ipsec policy (System view)
■ proposal
■ sa duration
■ security acl
■ tunnel local