Command Reference Guide

3Com Router 5000 Family and Router 6000 Family security-policy-server ● 281
Command Reference
security-policy-server
Purpose Use the security-policy-server command to specify the IP address of a
security policy server.
Use the undo security-policy-server command to delete the specified or all
security policy servers.
Syntax security-policy-server ip-address
undo security-policy-server [ ip-address | all ]
Parameters ip-address
Specifies a security policy server by specifying its IP
address.
all
All security policy servers.
Example Specify the security policy server with IP address 192.168.0.1.
[3Com] radius scheme system
[3Com-radius-system] security-policy-server 192.168.0.1
View This command can be used in the following views:
■ RADIUS Scheme view
Description You may specify up to eight security policy servers in a RADIUS scheme.
Configured with the security-policy-server command, the RADIUS server
accepts only the session control packets (carrying the security ACL) issued by the
specified security policy server or servers after endpoints pass security authentication.
You need to configure this command only when RADIUS, portal, and security policy
servers are not co-located.