Command Reference Guide

3Com Router 5000 Family and Router 6000 Family radius nas-ip ● 225
Command Reference
radius nas-ip
Purpose Use the radius nas-ip command to specify the source address of the RADIUS
packet sent from NAS.
Use the undo radius nas-ip command to restore the default setting..
Syntax radius nas-ip ip-address
undo radius nas-ip
Parameters ip-address
Specifies a source IP address.
Default By default, the source address is not specified, that is, the address of the interface
sending the packet serves as the source address.
Example Configure the router to send RADIUS packets from 129.10.10.1.
[3Com] radius nas-ip 129.10.10.1
View This command can be used in the following views:
■ System view
Description By specifying the source address of the RADIUS packet, you can avoid unreachable
packets as returned from the server upon interface failure. The source address is
normally recommended to be a loopback interface address..
This command specifies only one source address; therefore, the newly configured
source address may overwrite the original one.
Related Command nas-ip