Command Reference Guide

204 ● portal auth-network 3Com Router 5000 Family and Router 6000 Family
Command Reference
portal auth-network
Purpose Use the portal auth-network command to configure a network segment for
portal authentication.
Use the undo portal auth-network command to remove a specified
authentication network segment or all authentication network segments.
Syntax portal auth-network ip-address net-mask interface interface-type
interface-num
undo portal auth-network { [ ip-address net-mask ] interface
interface-type interface-num | all }
Parameters ip-address
IP address of a network segment.
net-mask
Subnet mask of the network segment.
interface-type
interface-num
Type and number of the Ethernet interface to which
the network segment is attached.
all
All configured authentication network segments.
Default By default, no authentication network segments are configured.
Example Configure the network segment for portal authentication.
[3Com] portal auth-network 192.168.0.200 255.255.0.0 interface Ethernet0/0/0
View This command can be used in the following views:
■ System view