Command Reference Guide

188 ● peer 3Com Router 5000 Family and Router 6000 Family
Command Reference
peer
Purpose Use the peer command to configure the subnet type in IKE negotiation.
Use the undo peer command to restore the default subnet type. You can use this
command to enable interoperability between the router and a Netscreen device.
Syntax peer { multi-subnet | single-subnet }
undo peer
Parameters multi-subnet
Sets the subnet type to multiple.
single-subnet
Sets the subnet type to single.
Default The default is single-subnet.
Example Set the subnet type in IKE negotiation to multiple.
[Router-ike-peer-xhy] peer multi-subnetpurpose_body
View This command can be used in the following views:
■ IKE-Peer view