Command Reference Guide

166 ● flow-control 3Com Router 5000 Family and Router 6000 Family
Command Reference
flow-control
Purpose Use the flow-control command to configure flow control mode.
Use the undo flow-control command to restore the default.
Syntax flow-control { hardware | software | none }
undo flow-control
Parameters none
No flow control.
software
Software flow control.
hardware
Hardware flow control , only valid on console and AUX
ports.
Default By default, TTY interfaces use hardware flow control.
Example Configure software flow control in user interface view.
[3Com-ui-console0] flow-control software
View This command can be used in the following views:
■ User Interface view
Description The configuration can become effective only when the serial interface works in the
asynchronous flow mode.
When the system is outputting, you may press <Ctrl+S> to halt outputting and
<Ctrl+Q> to continue.