Command Reference Guide

3Com Router 5000 Family and Router 6000 Family accounting-on ● 13
Command Reference
■ When receiving an Accounting-On packet, the CAMS server sends a response
packet to the router, locates and deletes information about the original online
users according to information about NAS-ID, NAS-IP, and session ID in the
Accounting-On packet, and ends the accounting based on the last accounting
update packet.
■ When receiving the response packet from the CAMS server, the router stops
sending Accounting-On packets.
■ If the router has sent the specified maximum number of Accounting-On packets
without receiving any response packet from the CAMS server, the router stops
sending Accounting-On packets.
■ The primary attributes of an Accounting-On packet (that is, the NAS-ID, NAS-IP,
and session ID) are often generated by the router automatically, where the NAS-IP
attribute is the IP address for the outbound interface of the packet by default. You
can also configure the NAS-IP attribute manually by using the nas-ip command, in
which case you must be sure to specify a correct and valid IP address.
■ These commands take effect only when used together with a CAMS server.
Related Command nas-ip