Command Reference Guide

3Com Router 5000 Family and Router 6000 Family static-lsp transit l2vpn ● 93
Command Reference
static-lsp transit l2vpn
Purpose Use the static-lsp transit command to configure a static LSP used in L2VPN
for transit LSR.
Use the undo static-lsp transit command to delete an LSP used in L2VPN of
transit LSR.
Syntax static-lsp transit lsp-name l2vpn incoming-interface interface-type
interface-num in-label in-label { nexthop next-hop-addr |
outgoing-interface interface-type interface-num } out-label out-label
undo static-lsp transit lsp-name l2vpn
Parameters lsp-name
LSP name
interface-type
Interface-num
Interface type and interface number
next-hop-addr
Next hop address
in-label-value
Inbound label value, in range of 16 to 1024
out-label-value
Outbound label value, in range of 16 to 1024
Example Add a static LSP used in 12vpn for the Serial0/0/0 of transit LSR, with inbound label
123 and outbound label 253.
[3Com -mpls] static-lsp transit citya-cityb l2vpn incoming-interface
serial0/0/0 in-label 123 nexthop 202.34.114.7 out-label 253
View This command can be used in the following views:
■ MPLS view
Description Two LSPs (one in each direction) should be created in advance and configured to the
transit LSR before creating a remote CCC connection.
Related Commands ■ static-lsp egress l2vpn
■ static-lsp ingress l2vpn