Command Reference Guide

92 ● static-lsp transit 3Com Router 5000 Family and Router 6000 Family
Command Reference
static-lsp transit
Purpose Use the static-lsp transit command to configure a static LSP for a transit
LSR.
Use the undo static-lsp transit command to delete an LSP for a transit LSR.
Syntax static-lsp transit lsp-name incoming-interface interface-type
interface-num in-label in-label-value { nexthop next-hop-addr |
outgoing-interface interface-type interface-num } out-label
out-label-value
undo static-lsp transit lsp-name
Parameters lsp-name
Name of LSP.
interface-type
Type of an incoming or outgoing interface.
Interface-num
Number of an incoming or outgoing interface.
next-hop-addr
Next-hop address.
in-label-value
Value of inbound label, ranging from 16 to 1023.
out-label-value
Value of outbound label, ranging from 16 to 1023.
Example Configure a static LSP for the serial interface Serial3/0/0 on a transit LSR, with an
inbound label of 123 and an outbound label of 253.
[3Com -mpls] static-lsp transit citya-cityb incoming-interface
serial3/0/0 in-label 123 nexthop 202.34.114.7 out-label 253
View This command can be used in the following views:
■ MPLS view
Related Commands ■ static-lsp egress
■ static-lsp ingress