Command Reference Guide

3Com Router 5000 Family and Router 6000 Family static-lsp ingress l2vpn ● 91
Command Reference
static-lsp ingress l2vpn
Purpose Use the static-lsp egress l2vpn command to configure a static LSP used in
L2VPN for ingress LSR.
Use the undo static-lsp egress l2vpn command to delete an LSP used in
L2VPN of ingress LSR.
Syntax static-lsp ingress lsp-name { l2vpn | destination ip_addr } { nexthop
next-hop-addr | outgoing-interface interface-type interface-num }
out-label out-label
undo static-lsp ingress lsp-name l2vpn
Parameters lsp-name
LSP name
next-hop-addr
Next hop address
interface-type
Interface-num
Interface type and interface number
out-label-value
Outbound label value, in range of 16 to 1024
Example Add a static LSP with destination address 202.25.38.1 at ingress LSR.
[3Com -mpls] static-lsp ingress citya-cityb destination 202.25.38.1 24
nexthop 202.55.25.33 out-label 237
View This command can be used in the following views:
■ MPLS view
Description With this command, you can configure a static LSP for ingress LSR, and set preference
and measurement value for it.
Two LSPs (one in each direction) should be created in advance before creating a
remote CCC connection.
Related Commands ■ static-lsp egress lvpn
■ static-lsp transit
■ debugging mpls