Command Reference Guide

90 ● static-lsp ingress 3Com Router 5000 Family and Router 6000 Family
Command Reference
static-lsp ingress
Purpose Use the static-lsp ingress command to configure a static LSP for the ingress
LSR.
Use the undo static-lsp ingress command to delete an LSP for the ingress
LSR.
Syntax static-lsp ingress lsp-name destination dest-addr { addr-mask |
mask-length } { nexthop next-hop-addr | outgoing-interface
interface-type interface-num } out-label out-label-value
undo static-lsp ingress lsp-name
Parameters lsp-name
Name of LSP.
dest-addr
Destination IP address.
addr-mask
Destination IP address mask.
mask-length
Mask length of destination IP address
next-hop-addr
Next-hop address.
interface-type
Type of network interface.
Interface-num
Number of network interface.
out-label-value
Value of outbound label, ranging from 16 to 1023.
Example Configure a static LSP for the ingress LSR heading for the destination address
202.25.38.1.
[3Com -mpls] static-lsp ingress citya-cityb destination 202.25.38.1 24
nexthop 202.55.25.33 out-label 237
View This command can be used in the following views:
■ MPLS view
Description In addition to configuring a static LSP for the ingress LSR, you can set precedence
value and metric value for the LSP with this command.
Related Commands ■ static-lsp egress
■ static-lsp transit
■ debugging mpls