Command Reference Guide

88 ● static-lsp egress 3Com Router 5000 Family and Router 6000 Family
Command Reference
static-lsp egress
Purpose Use the static-lsp egress command to configure a static LSP for an egress LSR.
Use the undo static-lsp egress command to delete an LSP for an egress LSR.
Syntax static-lsp egress lsp-name incoming-interface interface-type
interface-num in-label in-label-value
undo static-lsp egress lsp-name
Parameters lsp-name
Name of LSP.
interface-type
Type of network interface.
Interface-num
Number of network interface.
in-label-value
Value of inbound label, ranging from 16 to 1023.
Example Configure a static LSP named citya-cityb on the egress LSR.
[3Com -mpls] static-lsp egress citya-cityb incoming-interface
serial8/0/0 in-label 233
View This command can be used in the following views:
■ MPLS view
Related Commands ■ static-lsp ingress
■ debugging mpls