Command Reference Guide

70 ● peer enable 3Com Router 5000 Family and Router 6000 Family
Command Reference
peer enable
Purpose Use the peer enable command to activate the specified peer (group) in L2VPN
address family view.
Use the undo peer enable command to deactivate the specified peer (group) in
L2VPN address family view.
Syntax peer { group-name | peer-address } enable
undo peer { group-name | peer-address } enable
Parameters group-name
Peer group name, refers to the whole peer group.
peer-address
IP address of the peer, refers to the specific peer.
Default By default, unicast peer (group) of IPv4 address family is activated, while other peer
(group) is deactivated.
Example Activate the peer (group) 192 in the L2VPN address family view.
[3Com -bgp] peer 1.1.1.1 as-number 100
[3Com -bgp] l2vpn-family
[3Com -bgp-af-l2vpn] peer 1.1.1.1 enable
View This command can be used in the following views:
■ L2VPN Address Family view