Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display users ● 153
Command Reference
display users
Purpose Use the display users command to view the login information of the users on
each user interface.
Syntax display users [ all ]
Parameters all
Displays information about users of all user interfaces.
Example Display state about all user interface users.
<3Com> display users
UI Delay Type Ipaddress Username Userlevel
+ 0 CON 0 00:00:00 3
130 VTY 0 00:00:05 TEL [phone] tb 2
You can see information on all active terminal lines. The following
table describes the fields in the output.
Execute the display users all command on the console.
<3Com> display users all
UI Delay Type Ipaddress Username Userlevel
+ 0 CON 0 00:00:00 3
129 AUX 0
+ 130 VTY 0 00:00:16 TEL [phone] tb 2
131 VTY 1
132 VTY 2
133 VTY 3
134 VTY 4
All the terminal lines are displayed. The plus (+) signs indicate
active terminal lines.
View This command can be used in the following views:
■ Any view
Table 34 Fields in the output of the display users command
Field Description
+ Indicates the terminal line in use.
UI The first number and the second number are respectively the absolute index and
relative index of the user interface.
Delay Interval since the last input, in the format of hh:mm:ss.
Type User type, such as Telnet, SSH, and PAD
Ipaddress Location where connection is initiated, or IP address of the call-in host.
Username Username that the user uses to log in from this user interface. In this example,
this field is void because AAA authentication is not required on this terminal
line.
Userlevel User authority or level: 0 for visit, 1 for monitor, 2 for system, and 3 for manage.