Command Reference Guide

62 ● mpls lsr-id 3Com Router 5000 Family and Router 6000 Family
Command Reference
mpls lsr-id
Purpose Use the mpls lsr-id command to configure an LSR ID.
Use the undo mpls lsr-id command to delete an LSR ID.
Syntax mpls lsr-id ip-address
undo mpls lsr-id
Parameters ip-address
LSR ID, with the format like IP address, used to identify
an LSR.
Default By default, no LSR has an ID.
Example Set the ID of the LSR to 202.17.41.246.
[3Com ] mpls lsr-id 202.17.41.246
% Mpls lsr-id changed.
View This command can be used in the following views:
■ System view
Description LSR-ID address must be the interface address of the router, and the address must be
reachable in the entire network. In general, it is recommended to use the address of
the loopback interface.
As a premise for configuring other MPLS commands, this command you can
configure an LSR ID.
Related Command display mpls interface