Command Reference Guide

3Com Router 5000 Family and Router 6000 Family mpls ldp reset-session ● 59
Command Reference
mpls ldp reset-session
Purpose Use the mpls ldp reset-session command to reset a specified session on an
interface.
Syntax mpls ldp reset-session peer-address
Parameters peer-address
Corresponding LDP Peer address (in IP address format).
Example Reset the session at the interface Ethernet0/0/0.
[3Com -Ethernet0/0/0] mpls ldp reset-session 10.1.1.1
View This command can be used in the following views:
■ Interface view
Description After LDP is configured on an interface and LDP session is created, this command can
be used to reset a specific session on the interface. You only need to specify the
address of the peer corresponding to the session to be reset.
Related Commands ■ mpls ldp
■ mpls ldp enable