Command Reference Guide

3Com Router 5000 Family and Router 6000 Family mpls ldp path-vectors ● 57
Command Reference
mpls ldp path-vectors
Purpose Use the mpls ldp path-vectors command to set the maximum value of path
vector.
Use the undo mpls ldp path-vectors command to restore the default
maximum value of path vector.
Syntax mpls ldp path-vectors pv-number
undo mpls ldp path-vectors
Parameters pv-number
Maximum value of path vector, ranging from 1 to 32.
Default By default, pv-number is 32.
Example Set the maximum value of path vector to 23
[3Com ] mpls ldp path-vectors 23
Restore the default maximum value of path vector.
[3Com ] undo mpls ldp path-vectors
View This command can be used in the following views:
■ System view
Description This command should be configured before LDP is enabled on any interface. Its value,
which depends on actual networking situation, decides the loop detection speed in
LSP creation.
Related Commands ■ mpls ldp loop-detect
■ mpls ldp hops-count