Command Reference Guide

54 ● mpls ldp hops-count 3Com Router 5000 Family and Router 6000 Family
Command Reference
mpls ldp hops-count
Purpose Use the mpls ldp hops-count command to set the maximum hops of loop
detection.
Use the undo mpls ldp hops-count command to restore the default value.
Syntax mpls ldp hops-count hop-number
undo mpls ldp hops-count
Parameters hop-number
Maximum hops of loop detection, ranging from 1 to
32.
Default By default, the maximum hops of loop detection are 32.
Example Set the maximum hops of loop detection to 22.
[3Com ] mpls ldp hops-count 22
Set the maximum hops of loop detection to its default value, that is, 32.
[3Com ] undo mpls ldp hops-count
View This command can be used in the following views:
■ System view
Description This command should be configured before LDP is enabled on any interface. Its value,
which depends on actual networking situation, decides the loop detection speed
during LSP creation
Related Commands ■ mpls ldp loop-detect
■ mpls ldp path-vectors