Command Reference Guide

3Com Router 5000 Family and Router 6000 Family mpls ● 49
Command Reference
mpls
Purpose Use the mpls command in system view to enable MPLS globally and enter MPLS
view.
Use the undo mpls command in system view to disable MPLS globally.
Use the mpls command in interface view to enable MPLS on the interface.
Use the undo mpls command in interface view to disable MPLS on the interface.
Syntax mpls
undo mpls
Parameters None
Default By default, MPLS is not enabled.
Example Enter MPLS view in system view.
[3Com ] mpls
[3Com -mpls]
Execute the mpls command in interface view.
[3Com -Ethernet6/0/0] mpls
% Info: MPLS in the interface is starting, please wait...OK
View This command can be used in the following views:
■ System view
■ Routing Protocol view
■ Interface view
■ Virtual Interface view
Description Before you can enter MPLS view, you must configure the mpls lsr-id command
first. In addition, you can configure other MPLS commands only after you enter MPLS
view.
Related Commands ■ mpls enable
■ disable