Command Reference Guide

48 ● lsp-trigger 3Com Router 5000 Family and Router 6000 Family
Command Reference
lsp-trigger
Purpose Use the lsp-trigger command to configure topology-triggered LSP creation
policy.
Use the undo lsp-trigger command to remove the filtering conditions specified
by parameters and disable LSP trigger creation at any route.
Syntax lsp-trigger { all | ip-prefix ip-prefix }
undo lsp-trigger { all | ip-prefix [ ip-prefix ] }
Parameters all
Triggers LSPs at any route.
ip-prefix
Triggers LSPs only at the routes matching the specified
IP prefix list.
ip-prefix
IP prefix list, ranging from 1 to 19.
Default By default, all kinds of routing protocols are filtered out.
Example Triggers LSPs at all routes.
[3Com -mpls] lsp-trigger all
View This command can be used in the following views:
■ MPLS view
Description If no topology-triggered policy is configured, LSPs can be triggered at all host routes
with 32-bit masks.
If you import an IP-prefix rule without contents, LSPs can be triggered at all routes
according to the IP-prefix usage convention in VRP.
Related Command ip ip-prefix