Command Reference Guide

3Com Router 5000 Family and Router 6000 Family reset multicast routing-table ● 129
Command Reference
reset multicast routing-table
Purpose Use the reset multicast routing-table command to clear the route entry
in the multicast kernel routing table and remove the corresponding forwarding entry
in MFC.
Syntax reset multicast routing-table { all | { group-address [ mask {
group-mask | group-mask-length } ] | source-address [ mask {
source-mask | source-mask-length } ] | { incoming-interface
interface-type interface-number } } * }
Parameters all
All the route entries in multicast kernel routing table.
group-address
Address of the specified group.
group-mask
Address mask of the specified group.
group-mask-length
Address mask length of the specified group.
source-address
Address of the specified source.
source-mask
Address mask of the specified source.
source-mask-length
Address mask length of multicast source.
incoming-interface
Incoming interface of the specified route entry.
interface-type
interface-number
Interface type and interface number.
Example Clear the route entry whose group address is 225.5.4.3 from the multicast kernel
routing table.
<3Com> reset multicast routing-table 225.5.4.3
View This command can be used in the following views:
■ User view
Description The sequence of group-address and source-address can be reversed, but
the input group-address and source-address must be valid. Otherwise, the
system will prompt input error.
Related Commands ■ reset pim routing-table
■ reset multicast routing-table
■ display multicast forwarding-table