Command Reference Guide

106 ● peer reflect-client 3Com Router 5000 Family and Router 6000 Family
Command Reference
peer reflect-client
Purpose Use the peer reflect-client command to configure a peer (group) as a client
of the route reflector.
Use the undo peer reflect-client command to remove the existing
configuration.
Syntax peer group-name reflect-client
undo peer group-name reflect-client
Parameters group-name
Name of the peer group.
Default By default, there is no route reflector in the autonomous system.
Example Configure peer group named test to be client of the route reflector.
[3Com-bgp-af-mul] peer test reflect-client
View This command can be used in the following views:
■ IPv4 Multicast Subaddress Family view