Command Reference Guide

102 ● peer mesh-group 3Com Router 5000 Family and Router 6000 Family
Command Reference
peer mesh-group
Purpose Use the peer mesh-group command to configure an MSDP peer to join an Mesh
Group.
Use the undo peer mesh-group command to remove the configuration.
Syntax peer peer-address mesh-group name
undo peer peer-address mesh-group name
Parameters name
Name of an Mesh Group, being case sensitive. The
maximum length is 32 characters.
peer-address
Address of an MSDP peer to be a member of the Mesh
Group.
Default By default, an MSDP peer is not a member of any Mesh Group.
Example Configure the MSDP peer with address 125.10.7.6 to be a member of the Mesh
Group Grp1.
<3Com> system-view
[3Com] msdp
[3Com-msdp] peer 125.10.7.6 mesh-group Grp1
View This command can be used in the following views:
■ MSDP view