Command Reference Guide

52 ● display pim routing-table 3Com Router 5000 Family and Router 6000 Family
Command Reference
display pim routing-table
Purpose Use the display pim routing-table command to view the contents of the
PIM multicast routing table.
Syntax display pim routing-table [ *g [ group-address [ mask { mask-length |
mask } ] ] [ incoming-interface { interface-type interface-number |
null } ] [ dense-mode | sparse-mode ]
display pim routing-table [ **rp [ rp-address [ mask { mask-length |
mask } ] ] [ incoming-interface { interface-type interface-number |
null } ] [ dense-mode | sparse-mode]
display pim routing-table [ source-address [ mask { mask-length | mask
} ] [ group-address [ mask { mask-length | mask } ] ] [
incoming-interface { interface-type interface-number | null } ] [
dense-mode | sparse-mode ]
Parameters **rp
(*, *, RP) route entry.
*g
(*, G) route entry.
group-address
Address of the multicast group.
source-address
IP address of the multicast source.
incoming-address
Route entry of the specified incoming interface.
interface-type
interface-number
Specifies an interface by its type and number.
Example Display the contents of the PIM multicast routing table on the router.
<3Com> display pim routing-table
PIM-SM Routing Table
Total 0 (S,G) entry, 2 (*,G) entries, 0 (*,*,RP) entry
(*, 224.0.1.40), RP 20.20.20.30
Protocol 0x20: PIMSM, Flag 0x2003: RPT WC NULL_IIF
UpTime: 00:17:25, never timeout
Upstream interface: Null, RPF neighbor: 0.0.0.0
Downstream interface list:
Ethernet0/0/0, Protocol 0x1: IGMP, never timeout
(*, 225.1.1.1), RP 20.20.20.30
Protocol 0x20: PIMSM, Flag 0x2003: RPT WC NULL_IIF
UpTime: 00:08:45, never timeout
Upstream interface: Null, RPF neighbor: 0.0.0.0
Downstream interface list:
Ethernet0/0/0, Protocol 0x1: IGMP, never timeout
Matched 0 (S,G) entry, 2 (*,G) entries, 0 (*,*,RP) entry