Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display multicast routing-table static ● 47
Command Reference
display multicast routing-table static
Purpose Use the display multicast routing-table static command to view the
configuration information of static multicast route.
Syntax display multicast routing-table static [ config ] [ source-address [
mask | mask-length ] ]
Parameters config:
When this parameter is chosen, all the routing
information configured will be displayed. If this
parameter is not chosen, only effective routing
information is displayed.
source-address:
IP address of the multicast source.
mask:
Mask.
mask-length:
Length of mask. Because “1”s in 32-bit mask are
required to be continuous, the mask in dotted decimal
notation format can be replaced by mask-length
(mask-length is the number of continuous “1”s in the
mask).
Example Display the configuration information of static multicast route.
<3Com>display multicast routing-table static
100.10.0.0/16
RPF interface = 10.10.1.20(Ethernet0/0/0), RPF neighbor =
10.10.1.20
Matched routing protocol = <none>, route-policy = <none>, preference
= 1
Running config = ip rpf-route-static 100.10.0.0 16 Ethernet0/0/0 preference 1
View This command can be used in the following views:
■ Any view