Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display multicast routing-table static ● 43
Command Reference
display multicast routing-table static
Purpose Use the display multicast routing-table static command to view the
active multicast static routes.
Syntax display multicast routing-table static [ source mask ]
Parameters source
IP address of multicast source (unicast address).
mask
IP address mask of multicast source.
Example Display all active multicast static routes.
<3Com> display multicast routing-table static
22.22.0.0/16 [inactive]
RPF interface = serial0/0/0, RPF neighbor = 66.55.99.88
Matched routing protocol = = <none>, route-policy = <none>,
preference = 1
Running config = ip mroute 22.22.0.0 16 66.55.99.88 preference 1
Display the multicast static routes that exactly match the address 10.10.0.0/16.
<3Com> display multicast routing-table static 10.10.0.0 255.255.0.0
View This command can be used in the following views:
■ Any view
Description If no multicast source address is specified, all active multicast static routes will be
displayed.
Related Command display multicast routing-table static config