Command Reference Guide

3Com Router 5000 Family and Router 6000 Family aggregate ● 5
Command Reference
aggregate
Purpose Use the aggregate command to create a multicast aggregated record in the BGP
routing table.
Use the undo aggregate command to remove the aggregation.
Use the aggregate command without parameters to create one local aggregated
route and set atomic aggregation attributes.
Syntax aggregate address mask [ as-set ] [ attribute-policy route-policy-name ]
[ detail-suppressed ] [ origin-policy route-policy-name ] [
suppress-policy route-policy-name ]
undo aggregate address mask [ as-set ] [ attribute-policy
route-policy-name ] [ detail-suppressed ] [ origin-policy
route-policy-name ] [ suppress-policy route-policy-name ]
Parameters address
Address of the aggregated route.
mask
Network mask of the aggregated route.
as-set
Generates a route with AS_SET segment. This
parameter is not recommended to use when many AS
paths are aggregated.
attribute-policy
Attributes of the aggregated route.
detail-suppressed
No detailed route but the aggregated route is
advertised.
origin-policy
Filters the detailed route involved in aggregation.
suppress-policy
Detailed route determined is not advertised.
Default By default, the source address or source interface of the tunnel is not specified in the
system.
Example Create a multicast aggregated record in the BGP routing table and set the address of
aggregated route is 192.213.0.0.
[3Com-bgp-af-mul] aggregate 192.213.0.0 255.255.0.0
View This command can be used in the following views:
■ IPv4 Multicast Subaddress Family view