Command Reference Guide

284 ● set-overload 3Com Router 5000 Family and Router 6000 Family
Command Reference
set-overload
Purpose Use the set-overload command to configure overload flag bit for the current
router.
Use the undo set-overload command to reset the overload flag bit.
Syntax set-overload
undo set-overload
Parameters None
Default By default, no overload bit is set.
Example Set overload flag bit on the current router.
[3Com -isis] set-overload
View This command can be used in the following views:
■ IS-IS view
Description If a router is configured with the overload bit, it will be ignored by other routers in SPF
calculation. (However the directly connected routes will not be ignored.)
When the overload threshold is set, other routers should not send this router the
packets which should be forwarded by it.