Command Reference Guide

276 ● rip triggered 3Com Router 5000 Family and Router 6000 Family
Command Reference
rip triggered
Purpose Use the rip triggered command to enable trigger RIP (TRIP).
Use the undo rip triggered command to disable TRIP.
Syntax rip triggered
undo rip triggered
Parameters None
Example Enable TRIP.
[3Com ] serial 6/0/0
[3Com -Serial6/0/0] rip triggered
View This command can be used in the following views:
■ Interface view
Description TRIP only runs on PPP, frame relay, and X.25.
Routers are used on connection-oriented networks to allow potential connectivity to
many remote destinations. Circuits on the WAN are established on demand and are
relinquished when traffic subsides. Depending on the application, the connection
between any two sites for user data could be short and relatively infrequent.
Periodic updates are suppressed over the interface on which this feature is enabled.
Therefore, you can save money on demand circuit for which you are charged for
usage.
Whenever, routing information needs to be exchanged over demand circuits using
RIP, or triggered RIP it should be enabled.