Command Reference Guide

256 ● reflector cluster-id 3Com Router 5000 Family and Router 6000 Family
Command Reference
reflector cluster-id
Purpose Use the reflector cluster-id command to configure the cluster ID of the
route reflector.
Use the undo reflector cluster-id command to remove the configured
cluster ID.
Syntax reflector cluster-id { cluster-id | address }
undo reflector cluster-id
Parameters cluster-id
Specifies the cluster ID of the route reflector, in integer
or IP address format, with valid values from 1 to
4294967295.
address
Specifies the interface address of the route reflector’s
cluster ID.
Default By default, each route reflector uses its router ID as the cluster ID.
Example Set cluster ID for local router to identify the cluster.
[3Com -bgp] reflector cluster-id 80
[3Com -bgp] peer 11.128.160.10 reflect-client
View This command can be used in the following views:
■ BGP Unicast view
■ BGP Multicast view
■ VPNv4 view
Description Usually, there is only one route reflector in a cluster. It is the router ID of the reflector
that identifies the cluster. You can configure multiple route reflectors to improve the
stability of the network. If a cluster is configured with multiple route reflectors, use
this command to configure the identical cluster ID for all the reflectors.
Related Commands ■ reflect between-clients
■ peer reflect-client