Command Reference Guide

246 ● peer reflect-client 3Com Router 5000 Family and Router 6000 Family
Command Reference
peer reflect-client
Purpose Use the peer reflect-client command to configure a peer group as the route
reflector client.
Use the undo peer reflect-client command to cancel the existing
configuration.
Syntax peer group-name reflect-client
undo peer group-name reflect-client
Parameters group-name
Specifies the name of the peer group.
Default By default, no route reflector is in AS.
Example Configure the peer group "test" as the route reflector client.
[3Com -bgp] peer test reflect-clientpurpose_body
View This command can be used in the following views:
■ BGP view
■ VPNv4 view
Description Generally speaking, it is not necessary to configure this command for the peer group
because IBGP peers are in the default group. A single
peer peer-address
reflect-client command should be used to configure the route reflector clients.
Related Commands ■ reflect between-clients
■ reflector cluster-id