Command Reference Guide

228 ● peer 3Com Router 5000 Family and Router 6000 Family
Command Reference
peer
Purpose Use the peer command to configure the destination address of the peer to which
information is sent in unicast mode.
Use the undo peer command to cancel the set destination address.
Syntax peer ip-address
undo peer ip-address
Parameters ip-address
IP address of the peer router with which information
will be exchanged in unicast mode, represented in the
format of dotted decimal.
Default By default, do not send RIP packet to any destination.
Example Specify the sending destination address 202.38.165.1.
[3Com -rip] peer 202.38.165.1
View This command can be used in the following views:
■ RIP view
Description This command specifies the sending destination address to fit some non-broadcast
networks. Usually, it is not recommended to use this command.