Command Reference Guide

226 ● ospf trans-delay 3Com Router 5000 Family and Router 6000 Family
Command Reference
ospf trans-delay
Purpose Use the ospf trans-delay command to configure the LSA transmitting delay on
an interface.
Use the undo ospf trans-delay command to restore the default value of the
LSA transmitting delay on an interface.
Syntax ospf trans-delay seconds
undo ospf trans-delay
Parameters seconds
Transmitting delay of LSA on an interface (in seconds).
Valid values are 1 to 3600.
If no value is specified, the default value is 1 second.
Example Specify the trans-delay of transmitting LSA on the interface serial1/0/0 as 3 seconds.
[3Com ] interface serial1/0/0
[3Com -serial1/0/0] ospf trans-delay 3
View This command can be used in the following views:
■ Interface view
Description LSA will age in the "link state database" (LSDB) of the router as time goes by (add 1
for every second), but it will not age during network transmission. Therefore, it is
necessary to add a period of time set by this command to the aging time of LSA
before transmitting it.