Command Reference Guide

3Com Router 5000 Family and Router 6000 Family ospf timer hello ● 223
Command Reference
ospf timer hello
Purpose Use the ospf timer hello command to configure the interval for transmitting
Hello messages on an interface.
Use the undo ospf timer hello command to restore the default value.
Syntax ospf timer hello seconds
undo ospf timer hello
Parameters seconds
Interval for an interface to transmit hello message (in
seconds). Valid values are 1 to 255.
Default By default, the interval is 10 seconds for an interface of p2p or broadcast type to
transmit Hello messages, and 30 seconds for an interface of nbma or p2mp type.
Example Configure the interval of transmitting Hello packets on the interface serial1/0/0 to 20
seconds.
[3Com ] interface serial1/0/0
[3Com -serial1/0/0] ospf timer hello 20
View This command can be used in the following views:
■ Interface view
Related Command ospf timer dead