Command Reference Guide

3Com Router 5000 Family and Router 6000 Family ospf network-type ● 221
Command Reference
connects any two routers on the network. In other words, the network is full-meshed.
If the network cannot satisfy this condition, the interface network type must be
changed to point-to-multipoint. In this way, these two routers can exchange routing
information via a router directly connected with the two routers.
If there are only two routers running OSPF protocol on the same network segment,
the interface network type can be changed to point-to-point.
Note: When the network type of an interface is NBMA or it is changed to NBMA
manually, the peer command must be used to configure the neighboring point.
Related Command ospf dr-priority