Command Reference Guide

182 ● isis 3Com Router 5000 Family and Router 6000 Family
Command Reference
isis
Purpose Use the isis command to enable the corresponding IS-IS routing process and enter
the IS-IS view.
Use the undo isis command to cancel the specified IS-IS routing process.
Syntax isis [ tag ]
undo isis [ tag ]
Parameters tag
Name given to the IS-IS process. The name length
should be no longer than 128 characters. It can be 0,
which means null.
Default By default, IS-IS routing process is not started
Example Start an IS-IS routing process, in which the system ID is 0000.0000.0002 and the area
ID is 01.0001.
[3Com ] isis
[3Com -isis] network-entity 01.0001.0000.0000.0002.00
View This command can be used in the following views:
■ System view
Description For the normal operation of the IS-IS protocol, the isis command must be used to
enable the IS-IS process. Then the
network-entity command is used to set a
Network Entity Title (NET) for the router. And, at last, the
isis enable command
is used to enable each interface on which the IS-IS process runs. The IS-IS protocol is
actually enabled upon the completion of these configurations.
Only one IS-IS routing process can be started on one router.
Related Commands ■ isis enable
■ network-entity