Command Reference Guide

3Com Router 5000 Family and Router 6000 Family ipv4-family vpnv4 ● 179
Command Reference
ipv4-family vpnv4
Purpose Use the ipv4-family vpnv4 command to enter VPNv4 address family view of
BGP.
Use the undo ipv4-family vpnv4 command to delete all configurations in
VPNv4 address family view and return to IPv4 unicast address family view of BGP.
Syntax ipv4-family vpnv4 [ unicast ]
undo ipv4-family vpnv4 [ unicast ]
Parameters unicast
Enters VPN-IPv4 unicast address family view with this
argument.
Example None
View This command can be used in the following views:
■ BGP view
Description The ipv4-family vpnv4 command is used for BGP/MPLS VPN. For related
description, refer to "MPLS VPN" chapter in module "MPLS" of this manual.
The present VRP software platform only supports IPv4 unicast address of VPN.
Performing the
ipv4-family vpnv4 command will enter VPN-IPv4 unicast address
family view even if the
unicast argument is not specified.
Related Commands ■ ipv4-family
■ peer enable