Command Reference Guide

3Com Router 5000 Family and Router 6000 Family if-match acl ● 149
Command Reference
if-match acl
Purpose Use the if-match acl command to configure the IP address range to match the
route-policy.
Use the undo if-match acl command to cancel the setting of the match rule.
Syntax if-match acl acl-number
undo if-match [ acl acl-number ]
Parameters acl-number
Specifies the number of the access control list used for
filtering.
ip-prefix-name
Specifies the name of the prefix address list used for
filtering.
Example Display how to define one if-match clause. When the clause is used for filtering route
information, the route information filtered by route destination address through
address ACL 2010 is enabled to pass the if-match clause.
[3Com -route-policy] if-match acl 2010
View This command can be used in the following views:
■ Routing Policy view
Description Filtering is performed by quoting an ACL.
Related Commands ■ apply cost
■ apply ip-address
■ apply local-preference
■ apply origin
■ apply tag
■ if-match cost
■ if-match interface
■ if-match ip next-hop
■ if-match ip-prefix
■ if-match tag
■ route-policy