Command Reference Guide

3Com Router 5000 Family and Router 6000 Family filter-policy import 145
Command Reference
filter-policy import
Purpose Use the filter-policy gateway command to configure to filter the received
routing information distributed from the specified address.
Use the undo filter-policy gateway command to configure not to filter the
received routing information distributed from the specified address.
Use the filter-policy import command to configure the filtering to the
received global routing information.
Use the undo filter-policy import command to disable filtering to the
received global routing information.
Syntax filter-policy gateway ip-prefix-name import
undo filter-policy gateway ip-prefix-name import
filter-policy { acl-number | ip-prefix ip-prefix-name [ gateway
ip-prefix-name ] | route-policy route-policy-name} import
undo filter-policy { acl-number | ip-prefix ip-prefix-name [ gateway
ip-prefix-name ] | route-policy route-policy-name } import
Parameters ip-prefix-name
Name of address prefix list used for filtering the
destination addresses of the routing information.
acl-number
Access control list number used for filtering the
destination addresses of the routing information.
gateway ip-prefix-name
Name of address prefix list used for filtering the
addresses of the neighboring routers advertising the
routing information.
route-policy-name
Name of the routing policy used for filtering routing
information. It allows RIP to decide which routes
should be sent or received based on the fields acl, cost,
interface, ip, ip-prefix, and tag.
Default By default, RIP does not filter the received routing information.
Example Configure the filtering of the global routing information according to acl 2003.
[3Com -rip] filter-policy 2003 import
View This command can be used in the following views:
RIP view