Command Reference Guide
138 ● filter-policy export 3Com Router 5000 Family and Router 6000 Family
Command Reference
filter-policy export
Purpose Use the filter-policy export command to configure to filter the advertised
routing information by RIP.
Use the undo filter-policy export command to configure not to filter the
advertised routing information.
Syntax filter-policy { acl-number | ip-prefix ip-prefix-name | route-policy
route-policy-name} export [ routing-protocol ]
undo filter-policy { acl-number | ip-prefix ip-prefix-name |
route-policy route-policy-name} export [ routing-protocol ]
Parameters acl-number
Access control list number used for filtering the
destination addresses of the routing information.
ip-prefix-name
Name of address prefix list used for filtering the
destination addresses of the routing information.
route-policy-name
Name of the routing policy used for filtering routing
information. It allows RIP to decide which routes
should be sent or received based on the fields acl, cost,
interface, ip, ip-prefix, and tag.
routing-protocol
Routing protocol whose routing information is to be
filtered, including direct, isis, bgp, ospf, ospf-ase,
ospf-nssa, and static at present.
Default By default, RIP does not filter the advertised routing information.
Example Filter the advertised route information according to acl 2003.
[3Com -rip] filter-policy 2003 export
View This command can be used in the following views:
■ RIP view
Related Commands ■ acl
■ filter-policy import
■ ip ip-prefix