Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display ospf vlink ● 127
Command Reference
display ospf vlink
Purpose Use the display ospf vlink command to view the information about OSPF
virtual links.
Syntax display ospf [ process-id ] vlink
Parameters process-id
OSPF process ID. If no process ID is specified, the
command takes effect on all OSPF processes.
Example View OSPF virtual links information.
<3Com > display ospf vlink
OSPF Process 1 with Router ID 1.1.1.1
Virtual Links
Virtual-link Neighbor-id -> 2.2.2.2, State: Full
Cost: 0 State: Full Type: Virtual
Transit Area: 0.0.0.2
Timers: Hello 10, Dead 40, Poll 0, Retransmit 5, Transmit Delay 1
View This command can be used in the following views:
■ Any view
Table 29 Description on the fields of the display ospf vlink command
Field Description
Virtual-link
Neighbor-id
Router ID of the neighbor router at the other end of the virtual link
State State
Interface IP address of the local interface on the virtual link
Cost Route cost of the interface
Type Type of the link is virtual.
Transit Area ID of the transit area that the virtual link passes through. This area could not be a
backbone, stub, or NSSA area
Timers OSPF timers, defined as follows:
Hello Specifies the hello interval
Dead Specifies the neighbor dead interval
Poll Specifies the polling interval
Retransmit Specifies the interval for LSA retransmission
Transmit
Delay
LSA transmission delay on the interface