Command Reference Guide

114 ● display ospf interface 3Com Router 5000 Family and Router 6000 Family
Command Reference
display ospf interface
Purpose Use the display ospf interface command to view the OSPF interface
information.
Syntax display ospf [ process-id ] interface [ interface-type interface-number
]
Parameters process-id
OSPF process ID. If no process ID is specified, the
command takes effect on all OSPF processes.
interface-type
interface-number
Specifies an interface by its type and number.
Example Display the OSPF ethernet2/0/0 interface information.
<3Com > display ospf interface ethernet2/0/0
OSPF Process 1 with Router ID 2.2.2.2
Interfaces
Area: 0.0.0.0
IP Address Type State Cost Pri DR BDR
10.0.0.2 Bcast BackupDR 1 1 10.1.1.1 10.0.0.2
80.0.0.1 NBMA DR 1562 1 80.0.0.1 None
Area: 0.0.0.1
IP Address Type State Cost Pri DR BDR
60.0.0.1 NBMA DR 1562 1 60.0.0.1 None
90.0.0.1 NBMA DR 1562 1 90.0.0.1 None OSPF
Process 1 with Router ID 1.1.1.1
Interfaces
Interface: 10.110.10.2 (Ethernet0/0/0)
Cost: 1 State: BackupDR Type: Broadcast
Priority: 1
Designated Router: 10.110.10.1
Backup Designated Router: 10.110.10.2
Timers: Hello 10, Dead 40, Poll 40, Retransmit 5, Transmit Delay 1