Command Reference Guide

102 ● display loadsharing ip address 3Com Router 5000 Family and Router 6000 Family
Command Reference
display loadsharing ip address
Purpose Use the display loadsharing ip address command to view the statistics
about the unbalanced load sharing based on interface bandwidth, including the
number and ratio of the packets sent from the interfaces related to the equal-cost
routes to a network address.
Syntax display loadsharing ip address ip-address mask
Parameters ip-address
IP address of the destination network, in dotted
decimal format.
mask
Dotted decimal subnet mask or subnet mask length.
Example Display information about load sharing on all the interfaces corresponding to the
equal-cost routes to the network 10.2.1.0/24.
[3Com ] display loadsharing ip address 10.2.1.0 24
There are/is totally 3 route entry(s) to the same destination network.
Nexthop Packet(s) Bandwidth[KB]Flow(s) Interface
10.1.1.2 763851 100000 0 Ethernet0/0/0
10.1.2.2 1193501 155000 0 Atm1/0/0
10.1.3.2 15914 2048 0 Serial2/0/0
BandWidth:48:75:1
Packets:47:74:1
Flows:0:0:0
View This command can be used in the following views:
■ Any view
Description You can view these equal-cost routes using the display fib command.
Related Command display fib