Command Reference Guide

256 ● sot sdlc-status secondary 3Com Router 5000 Family and Router 6000 Family
Command Reference
sot sdlc-status secondary
Purpose Use the sot sdlc-status secondary command to set the role of the router to
SDLC secondary node.
Use the undo sot sdlc-status command to delete the role setting.
Syntax sot sdlc-status secondary
undo sot sdlc-status
Parameters None
Default By default, no role is assigned to the router.
Example Set the role of the router to SDLC secondary node.
[Router-Serial0/0/0] sot sdlc-status secondary
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description In SOT local acknowledgement mode, you must assign a role to the router, depending
on the position of the router in the sequence of primary (IBM host), secondary
(router), primary (router), and secondary (terminal). If the router is connected to an
IBM host, its role is SDLC secondary node. In broadcast mode, you must set the role of
the router to secondary, regardless of whether it is connected to an IBM host or to a
terminal. Other SOT modes however, do not involve the role of secondary node.
Related Commands ■ ip route
■ display ip interface
■ display interface